Skip to content

SG2557-80PG-9.75B | 24 V Hub Gear Motor

Independent historical source reference — based on the original 2024-05-21 Rev A SG2557-80PG-9.75B wheel-hub reduction assembly drawing. This identifier is not interchangeable with SG-2877 or SG-2878, and current standard availability is not confirmed.

Download SG2557 English Dimension Reference PDF Request Original 2D / Configuration Review

Download scope: This one-page English PDF is a transcription of specified source dimensions and drawing requirements; it is not the original manufacturing drawing, a fully verified mounting drawing, a released CAD file or a certification document. The original Chinese Rev A source PDF and any 3D CAD file for this model have not been published in the repository.

Source Drawing Identity

Item Source reference
Model SG2557-80PG-9.75B
Product family BLDC hub gear motor with planetary reduction
Drawing label SG2557-80PG-9.75B wheel hub reduction assembly
Source revision A
Drawing date 2024-05-21
Current manufacturing availability Not confirmed
Controller Not shown as integrated; confirm separately

Motor and Output Specifications

Parameter 2024 source drawing
Rated voltage 24 VDC
Motor rated current < 3 A
Motor rated speed 1,500 ±10% rpm
Motor rated torque 0.3 N·m
Locked-rotor current < 8 A
Reduction ratio 9.75:1
Gear output rated current < 3 A
Gear output rated speed 130 ±10% rpm
Gear output rated torque 3 N·m
Source stated peak output torque 10 N·m (peak duration not specified)
Ingress protection IP66 requirement shown on source drawing; independent certification not supplied

Do not use the 10 N·m peak value as a continuous rating. The drawing does not define a validated peak duration, thermal limit or working duty cycle. The 2024 source drawing is not proof that this configuration is the current standard catalog product.

Source-Derived Dimensional Reference

Mechanical item Drawing reference
Axial dimension annotated on side view 116.00 mm (do not treat as verified installed overall length)
Additional side-view segment 63 ±0.1 mm
Front visible diameters Ø93.00 ±0.10 mm and Ø80.00 +0/−0.15 mm
Rear visible diameter Ø84.00 ±0.10 mm
Shaft feature Ø16.00 −0.05/−0.12 mm
Bore feature Ø10.50 mm
Shaft projection reference 28.00 +0/−0.2 mm
External wiring Three phase wires and six Hall/sensor wires; lead length customisable

The source drawing also notes 20 AWG phase wiring, 24 AWG auxiliary wiring, RoHS compliance requirements and more than 72 hours of salt-spray appearance resistance. These are source instructions, not verified test certificates. The mounting hole pattern, thread depths and all datum-controlled fits require the original source drawing and engineering approval.

Configuration and File Status

Requested file Current public status
English source-dimension checklist PDF Download available (Rev0.1)
Original 2024 Rev A 2D assembly drawing Not published here
Configuration-matched 3D STEP / Parasolid No verified public model
Factory-controlled mounting/tolerance drawing Engineering confirmation required

This older SG2557 source must not be used to override SG-2877 or SG-2878 specifications, waterproof ratings, housing dimensions, power ratings or source identifiers.

SG-2877 (3 Nm) · SG-2878 (6 Nm) · Hub Gear Motor Family · Engineering Enquiry

Guangdong SigGear Drive Intelligent Technology Co., Ltd.
International Sales Department · wangwanrong@siggear.com