36P Planetary Gearbox Mechanical Interface v1.0¶
Status: Public engineering evaluation reference
Release date: 2026-10-06
Controlled drawing code: SG01PD36
This page summarizes the mechanical-interface information that is suitable for public early evaluation from the current SigGear controlled 2D drawing.
Warning
This page is not a manufacturing drawing. Use the current controlled drawing for final tolerances, detailed shaft geometry and production design release.
Controlled Envelope¶
| Item | Controlled / published reference |
|---|---|
| Nominal gearbox diameter | 36 mm |
| Output-side extension shown on drawing | 25.0 mm (+0.1 / -0.3) |
| Gearbox body length | L, stage-dependent |
| Output-side interface | 4 × M3 threaded holes, depth 4.5 mm, with Ø28.0 ±0.1 reference circle; output keyway DIN 6885-A3×3×16 |
| Input-side interface | Ø16.0 center opening; 2 × Ø3.1 mounting holes with 22.0 ±0.1 mm opposed spacing |
Stage-Dependent Length¶
The controlled drawing uses L for the gearbox body length. L changes with the selected stage count.
Use the 36P product page for the currently published 1-stage to 4-stage length and ratio table.
Public Simplified CAD¶
Download 36P Simplified STEP - 4-Stage Reference
The released public STEP is a single-solid simplified external-interface model for early packaging and mechanical Design-In. It represents the 4-stage reference configuration only and intentionally omits the internal planetary transmission construction.
A detailed full-assembly 36P STEP is still retained as configuration-controlled engineering CAD and is not published as a raw download.
For another stage count or final production release, request the configuration-matched controlled CAD / drawing.
Request 36P Controlled CAD / Drawing
Design-In Boundary¶
Before final design freeze, confirm:
- Stage count and reduction ratio
- Exact gearbox body length L
- Output shaft / mounting interface
- Motor-side pilot and shaft interface
- Motor speed and torque operating point
- Radial / axial load condition where relevant
- Configuration-specific CAD revision
Engineering Contact¶
Wanrong Wang
International Sales / Sales Engineer, SigGear
wangwanrong@siggear.com